Grommet wiring harness Z50 K0-K1, CT70, SL70, XL70 and others
Seat Z50A K0-K2. Will come boxed
2 position switch. Hi-Lo beam selector. Z50, CT70 and others. Requires replacement wire with gray sheathing to be compatible with some models. Wiring available on after market parts page.
Kill switch replacement made by Honda. Wiring slightly longer. For Z50A combine with replacement 2-wire kit in gray sheathing
$46.95 LIMITED SUPPLY
Small wire tie secures cable and wires to frame directly under tank all years
Original Honda grips for QA50K0, and early CT70, Z50.
Grommet throttle cable. QA50, Z50, CT70 and others
Original Honda grips for QA50K1 - K3, Z50AK3-1978, and later model CT70K1-K3
OEM Honda - throttle kit
Screw, throttle stop
Holder, throttle cable
Petcock gasket, valve
Complete petcock assembly with strainer and packing. QA50, MR50, Z50 K0-78
Slotted tank bumper.Very early Z50 frame had flat tabs on the side. These are only correct for those early frames.
Honda QA50 and Z50 K3-K6 carburetor gasket set
OEM Honda rubber tank cushion for QA50 and Z50 K0/K1/K2.
Rear tank cushion Z50A K3-78, Z50R to 1996
OEM Honda rubber rear, tank strap for QA50 and Z50 K0/K1/K2.
OUT OF STOCK
5mm oval screws found on engine covers for original points inspection cover on Z50A, SL70, CT70, CL70, XR75 (4-speed) and clutch cover.
Also found on MR175, MT125, MT250, CL100 CB100, SL100, CB125, CL125, SL125, TL125, XL100 XL125 oil rotor cover. 5x12, 5x16, 5x25 - Choose length.
5mm x 10mm flat screws found on clutch outer on Z50A, SL70, XL70, CT70, and CL70.
6mm x 16mm flat screws found on magneto, stator plate on XR75, MR50, Z50A, Z50R, SL70, CT70, CT70H. Also found on clutch actuator assembly of 4-speed horizontal motors.
OEM 6mm pan screw. Sold each. This item from 6x6mm to 6x28mm
OEM 6mm pan screw. Sold each. This item from 6x32mm to 6x135mm